中国医科大学学报

中国医科大学学报
  • 中文核心期刊
  • 中国科技核心期刊
  • 中国高校百佳科技期刊
  • BA、CA收录

中国医科大学学报 ›› 2017, Vol. 46 ›› Issue (10): 882-886.doi: 10.12007/j.issn.0258‐4646.2017.10.005

• 论著 • 上一篇    下一篇

粘接剂排溢沟对后牙氧化锆全冠适合性的影响

曹程1,李平1,屈直2   

  1. 锦州医科大学1 研究生院;2 附属第二医院修复科,辽宁 锦州 121000
  • 收稿日期:2017-03-31 出版日期:2017-10-30 发布日期:2017-10-16
  • 通讯作者: 屈直 E-mail:Quzhi7777@sina.com
  • 作者简介:曹程(1990 -),男,硕士研究生
  • 基金资助:
    辽宁省自然科学基金(2013022012)

Effect of Adhesive Overflow Grooves on the Adaptation of a Molar Zirconia Full Crown

CAO Cheng 1,LI Ping 1,QU Zhi 2   

  1. 1 Postgraduate School,Jinzhou Medical University,Jinzhou 121000,China;2 Department of Prosthodontics,The Second Affiliated Hospital of Jinzhou Medical University,Jinzhou 121000,China
  • Received:2017-03-31 Online:2017-10-30 Published:2017-10-16

摘要: 目的 研究粘接剂排溢沟对后牙全冠适合性的影响。方法 三维建模一颗下颌第一磨牙,在Rhinoceros 5.0软件中设计4种预备体模型:A为常规全冠预备设计,B、C、D分别在A组的基础上设计1、2、4个粘接剂排溢沟,3D打印树脂预备体各5个。根据 A预备体设计全冠,CAD/CAM制作氧化锆全冠20个,完全随机分为4组。三维扫描仪扫描试件,进行偏差分析及壁厚分析。硅橡胶 法复制冠与预备体之间的间隙,金相显微镜下观察,并测量间隙大小。SPSS 17.0软件进行统计分析。结果 全冠边缘和内部间 隙从大到小依次为A组、B组、C组、D组,两两比较差异有统计学意义(P < 0.05)。结论 粘接剂排溢沟能显著提高全冠的适合性, 且排溢沟数量越多,全冠适合性越好。

关键词: 粘接剂排溢沟, 边缘适合性, 内部适合性

Abstract: Objective To study the effect of adhesive overflow grooves on the marginal and internal adaptation of a molar zirconia full crown. Methods A three-dimensional model of a mandibular first molar was established. Four crown preparations(A-D)were designed: a was a conventional full crown design,and B,C,and D included 1,2,and 4 adhesive overflow grooves,respectively,designed on the basis of A. Five resin preparations were created for each group using three-dimensional(3D)printing. According to the a design data,20 CAD/ CAM zirconia crowns were prepared and randomly divided into four groups. The tooth,preparations,and crowns underwent 3D scanning for 3D deviation analysis and 3D wall thickness analysis. The gap between the crown and the preparation was replicated with silicone rub- ber,and then observed with a metallographic microscope and measured. Data were statistically analyzed with SPSS 17.0. Results Among the groups,marginal and internal clearance was A>B>C>D. The comparison between every two groups was statistically different(P < 0.05). Conclusion Increases in the number of overflow grooves result in significant increases in the marginal adaptation and internal adaptation of a full crown.

Key words: adhesive overflow groove, marginal adaptation, internal adaptation

中图分类号: 

  • R783.3
[1] 张亚君,屈直. 聚合度和隙料厚度对计算机辅助设计与制作全瓷冠边缘和 内部适合性的影响[J]. 中国医科大学学报, 2017, 46(10): 921-923.
[2] 霍欢,殷家悦,艾红军. 不同印模方式对全冠边缘及内部适合性的影响[J]. 中国医科大学学报, 2016, 45(7): 656-658.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!

中国医科大学学报版权所有©2018

未经允许,严禁擅自转载本站图文资料

地址:中国 沈阳市沈北新区蒲河路77号 110122

辽ICP备05014850

JOURNAL OF CHINA MEDICAL UNIVERSITY

ADDRESS: NO.77 PUHE ROAD

SHENYANG NORTH NEW AREA, SHENYANG

LIAONING PROVINCE, P.R. CHINA